Rolo
February 6, 2026, 9:02pm
3
Thank you for your honesty and willingness to help! Mistakes happen and not everyone has the courage to stand up and say “Well… shucks, I did it.” Even if it was a potential bit slip or other cause.
You can donate to the cost of a new board here . And here’s a link to a post showing what goes into the replacement when @zipset and his team were helping us keep these going.
Today the spoil board was replaced on the CNC! This is good news for folks, but also comes with another warning about always checking your depth. The boards lately have been replaced roughly once per month. In the past they have lasted much longer.
Below is the process of what it takes to replace it. This was done voluntarily but at the cost of their time on the machine as well as the cost of Asmbly for a new spoilboard. This particular change also included a new gasket for a particularly bad g…