It seems like Vacuum 2 on the big CNC isn’t operating, I wasn’t getting full hold on my panels today and I used the whole 5x10 area. It would be great if someone could troubleshoot this, machine is working fine otherwise and I think it’s confined to the lower half of the bed. The upper half of the bed’s vacuum seems to be working fine.
1 Like
The vacuums aren’t zoned separately on the bed. They both go to the same vacuum tank system. I.e. Vacuum 1 can supply all zones, vacuum 2 can supply all zones, or both work on tandem to do the vacuum to all zones.
Took a look and zones all seem ok as expected, However vacuum 2 will not turn on so that is a definite problem lowering the suction.
The contactor just tripped. Make sure the filter is clean. Then reset it. It’s in the top right of the front side of the cabinet. There are two next to eachother
1 Like
Thanks for solving this @EricP