Widebelt Sander

Hi all. The widebelt sander’s settings were off again this morning - It’s been recalibrated and set again.
I’m guessing this is happening when other buttons/settings are pushed on the control panel.
Wanted to remind everyone that the only buttons on the control panel that should be pushed are the up and down arrows. Once to get the thickness of your board , and then hitting the up arrow after each pass.
It had some heavy use last night based on the amount of sawdust and epoxy left around it .

People should be cleaning up around the sander when they use it.

2 Likes

Here’s my first pass at a button guard.

5 Likes