What tracks are available at the wood shop

Hello. This weekend I plan to do a table top glue up and will need to trim the ends off with a track saw. If memory serves we have a makita at the shop but I can’t remember what brand tracks.

I’m looking to buy this square to make sure I get square cuts but want to avoid buying the wrong one.

We do have a track saw on site with some tracks. We have a few carpenter squares, small and quite large, in order to get your markings on the board.

Using the track saw and double checking with your carpenter squares, you can make your markings and make your cuts. You shouldn’t need to buy extra measuring and marking tools for this particular case.


Some recommendations. You may want to use either the panel saw or the track saw to make rough cuts. This can help you break down your pieces so you can move them to the table saw for more accurate cuts.

If your cuts don’t need to be exact and spot on, you can get away with a track saw and the marking tools we have in the building without having to buy any sort of peripherals. I’ll also suggest that you don’t need any of those peripherals. I built 11 cabinets on site for my kitchen by rough cutting with a track saw or panel saw and fine cutting with our table saw.

That said… if you are looking for an excuse to buy a new tool… you need it! Nuff said!

3 Likes

Thank you Rolo for all the helpful information! I would love to use the table saw as I’m very familiar with it already; however, is it really possible to do with a table top that is 72" x 39"? I am genuinely asking because I’m a noob and I have yet to see a single YouTube video where someone does the final trim after glue up with a table saw. I’ve seen track saws and circular saws only. I thought I might try to saw all the boards to the right length before glue up and pray my glue up is lined up perfectly but that seems like too much risk to me. I’m trying to get exactly 2" overhang over the table base itself.

I don’t like I responded too well to your original post. I would not use a table saw for this. It’s definitely too big to run on our saws, at least safely anyways.

Track saw should serve you just fine!

You can rip the 39” dimension on the table saw, but 72” cross cut would be tricky. I think the fences max out around 50”. Depending on the thickness of the tabletop, the table saw might be impractical for any of it.

I know we have one Makita fence and some from Wen (which copy of the Makita standard).

If it was me, Im lazy and dont like to complicate my life, so the panel saw to trim the length (good side goes down on the panel saw) and tablesaw for the the width. Plywood sheets are 48 X 96 and I cut them down by myself. So you should not have a problem cutting 39" with some help. You could do both on the panel saw but is just too much hassle to flip the saw to cut horizontally and you have an industrial table saw that can do a better job. Good kuck!