The fixture table has a twist

I already showed James & Ethan. But I wanted to point out that the new welding fixture table has a twist to it. This was over a 50" distance. It’s quite a bit more pronounced over 96"

hmm, not good

Given the measurements you mentioned, I assume the two tables have been joined. How was that done?

This was on the singular tabletop.

We have two table tops and one set of legs. Is the table were talking about a square 48" by 48"?

Only one table has been assembled with legs, so its one 24 x 36 rectangle. The other hasnt been assembled

1 Like

We ought to take a look at the other table top to see if it has issues.