Hi yall!
as I go to start the large Laguna cnc I’m getting an error message that the y axis is beyond the limit.
i had this issue yesterday and easily fixed it by clicking the top left corner in the “XY datum Position” section in the design tab. Not having the same luck today.
Hoping to get this done tonight or tomorrow if anyone could help me trouble shoot.
Thanks!
Shelby
Where is your origin in your design versus the origin on the CNC? I.e. are they both lower left,
This sounds like a datum mismatch as Frank suggested. Assuming the machine is moving correctly and homed correctly, y out of limits is an error saying your project is trying to go beyond the programmed limits of the machine.
Was able to fix it - just needed to click the bottom left corner 
thank you for responding!!