Rolo
(Robert Szabo)
1
Either the bed is not level, or the laser lens rails are misaligned.
There Is a noticable gap when using the focusing tool on the top left and bottom right of a 2’x4’ sheet.
At least 1/16".
Right side is lower.
The laser can still be used, but be careful on full cuts.
Top right
Bottom right, same Z axis
dannym
(danny w miller)
2
its max deviation is 0.8mm. that’s pretty good for the bed size and could only cause very small differences in cutting
main prob was the lens was installed upside down and #3 adjustment was at the margins of acceptable alignment, and head was loose.
all fixed
1 Like
Rolo
(Robert Szabo)
3
Thank you for the update Danny! Great news.