Hello!
TLDR: Conveyor belt printer up for grabs, if not something that can go to the makerspace itself (due to limited space/lack of want)
I got an Ideaformer IR3 V1 a few years ago to print an absurdly large sword (Sephiroth’s Masamune, scaled roughly to size and about 8 feet in length)
Initially, when i first got it, i was able to mostly lock in, get everything roughly set up just about right, the height on the conveyor belt was a bit tempramental, but i managed well enough for this being my first printer, i think. Then i moved, and couldnt ever be bothered to set it up again and go through the whole finnicky setup process again. That coupled with me being a bit of a noob when it comes to messing around with slicer settings and all therein. I’d love to donate the printer to ASMBLY, or at the very least to a good home with someone whos been wanting one and can give this thing the attention it deserves!
The only defect i can think of off-hand is the belt has a somewhat small-but-notable horizontal scratch from an early mis-calibration that had the print head drag along the belt (my B; technically it can be replaced, but i also doubt itll super matter unless youre going for absolutely perfect print quality, y’know?