Hermes stuck while printing

When I came in today I saw that someone’s print is stuck halfway on Hermes and had an emergency stop. I turned it off, but it still needs to be cleaned up.

It looks like it was @kyle.spafford. If someone can take a photo of the result, I’d appreciate it.

Yes, this was mine. I will be in this evening to clean up and investigate. I am curious what happened. The current part is almost identical to a part that printed successfully before.

Check the z-offset. It should be around 1.070 roughly. I was tuning it yesterday with @Kirby117101 and realized that we adjusted the live-z offset, not the z-offset.

Here are the steps to do that: