Folks, Good evening all!
Can any of you please give me a quote for 12x pairs of these glass art supports?
Base piece could preferably be 5/8” unthreaded bar steel as well. Artist is looking for someone else that will do a quality job with neater welds to match the effort that goes into base and fused glass.
What would be the cost & lead time for all 12 pairs? (I can finish at home!)
End result would be to hold up my friend’s art on the bases I make like the one pictured below.
Thanks, Steve
So this is 5” tall, 1” wide, and 5/8” deep? It’s rounded rectangular pieces, except for the bottom 1”, which is threaded, presumably 1/2”-13 threads?
This could be done as a single piece without welding, easily in aluminum, with a bit more difficulty in steel.
Ethan, I don’t have exact measurements, but the end result is like this:
Thanks! Steve
Steve Kupec, Owner
Living on the Edge Woodwork
LivingOnTheEdgeWoodwork@gmail.com
512-473-9796
OK, that’s quite different than what I pictured from the 2D drawing. Is that design, with round pieces mounted on opposite corners of a square piece, an essential aesthetic element? Or do you just need a functional equivalent?
Either way, you have to provide the exact thread specifications or they won’t fit in the base.
