Help making acrylic stamp

[JOSEGAYTAN]

Has been talked about before here is tge link.

Engraving acrylic on Tarkin -- any suggestions for starter settings?

Hi all. I’d like to create a small stamp for debossing leather using 1/8 cast acrylic, as shown in this video: [DIY Leather Stamp Plates With A Laser Engraver] Since I don’t have a whole lot of acrylic on hand to test with, I’d like to start at least somewhat close to decent power/speed/line settings. Does anyone have any suggestions on where to start, assuming that the design (i.e. devil below) is ~1" in height and the desired depth is about 1/16"? [image] Thanks!