A friend wanted to get rid of an old Form2, plus Cure/Wash, with some resin. It has seen some use, possibly in a high school classroom. It has not been in use for some time, resin was left in it, and it is a bit messy in and around the tank. I have about 10 resin cartridges, some open, some still sealed.
Does anyone have advice for using this setup?
- Form2 was released in 2015 and support will end after 2025. Will it still be worth using after that?
- Any critical dos/don’ts for cleaning (including Cure and Wash)?
- Are the open resins usable?
- Are the Cure/Wash appliances required for all resins? I was under the impression that some resins could be used without those, but now I’m second guessing that.
Asking here first, I might post on some Formlabs specific forum as well.
