Adjusting the router table fence

It seems like the out feed side of the fence is slightly behind the in feed and the metal bracket overhangs both melamine pieces by a bit. Can that be adjusted?

I’m trying to use a lock miter bit. That requires one side to be cut vertically and the mating piece to be horizontal. I think I can solve the out feed issue on the horizontal piece by taping a long piece to the top. I don’t know how to solve for the vertical piece not sitting flush against the fence and metal track at the same time.

@mgmoore’s fence might have helped but it has gone missing

I’ll take a look at all of this when I am back in town next week. And I still plan to finish my specialty fence, but obviously other things have demanded my time. The prototype was starting to fall apart though, so I pulled it off the table.