3D Printing Policy Updates

Effective today, we’re updating a couple policies in the 3DP space, and adding one more.

  1. Skedda hours booked in the 3DP categories will not count against your 25 hr/wk allotment
  2. Users should now book the entire print time on Skedda, instead of setup time only
  3. Users may not utilize more than 2 printers simultaneously

It was often hard and/or annoying to figure out when a previous print should be ending, and the setup time on prints is usually negligible. This will hopefully make things more obvious for everyone.

These policies are also reflected on the Asmbly wiki and in the Skedda info box for every 3D printer.