Anybody else having trouble face jointing material that’s close to the full six inch capacity of the jointer? Even taking 1/32 at a time it wants to dig in hard on the outside edge of machine and barely touch the material closer to the fence.
Was just curious if anyone else was seeing something similar.
That’s a thing that can happen - sounds like we need to check the alignment of the infeed table to the cutter head. I’ve re-shimmed other jointers but not Asmbly’s.
@cfstaley is this on your radar?
It was not on my radar. I’ll be in tomorrow and take a look. I haven’t run into that issue before.
I only got a brief look at it. I’ll be back in tomorrow. It definitely needs some teeth rotations, but that was all the time that I had.