Cnc push sticks

After figuring out fusion only wants to post in metric, I finally got a few of these cut

They’re nothing fancy made from scraps, but I want to see how long these last and what people think before I go spending a ton of time revising the design

Ideally I would want to glue a piece of sandpaper or grippy material to the bottom similar to the yellow and orange sticks have

I also want to make them a smidge longer and the handle a bit higher

I cncd the shape, then used the bandsaw to make the foot, rounded over the edges

I put one in the fence caddy on the tablesaw, the other 3 are in the bottom drawer of the miter station whenever they get too blasted


Very nice! Honestly we should just have these scattered around everywhere so people never have an excuse of not finding a push stick