Apollo Z-leveling issue

I tried to start a quick print on Apollo, and it kept trying to calibrate the Z-level, but never seemed to succeed. Attached a picture of the screen, but couldn’t figure out how to resolve the issue.

Any pointers? I was a bit afraid to mess with it too much without knowing what I was doing.

Just getting around to seeing this, you would need to go to the calibration menu and then calibrate XYZ

I think the magnetic plate was not on snug

now that you mention it @ashleyrlee, the rear looks to be higher and further back from the build surface.

1 Like

I adjusted it and it fixed the problem

1 Like